Novexx Solutions ALX 92x, Service Manual, Page: 438 / 824

06/16 Rev. 04 SERVICE MANUAL Service Electronics Gen. 3
64-xx Gen. 3 – DPM Gen. 3 – PEM – ALX 92x Gen. 3 – ALX 73x (PMA)
69
3. Insert standard self-adhesive material (paper label on backing paper) into
the printer.

y should count at least 100 digits higher than the y value measured with bare
backing paper.
4. If y doesn´t match this range: modify the x value by pressing the Apply or
Feed button.
5. Press the online button to save the setting.
By doing so, the Fullsize LS is ready set.
Rewinder dancer
lever LS Now, the settings of the rewinder dancer lever light sensor are displayed::
x: setting value of the LED current.
y: value measured by the sensor.

This connector is solely used in ALX 92x, and only, if the rewinder dancer le-
ver sensor is connected to the CPU board. This is the case, if the machine is
equipped with M5A output stages (in series since 1/2012). If this condition is
not matched, skip this section by pressing the online button.
Default setting for LED current: x = 255
1. If necessary
1
, reduce the LED current by pressing the Apply button.
2. Press the online button to save the setting.
By doing so, the rewinder dancer lever sensor is ready set.
Sensor adjust
x AUX y
1) See chapter Light sensor at the rewinder dancer lever (ALX 92x)

on page 70.