Novexx Solutions ALX 92x, Service Manual

Page: 380 / 824

06/16 Rev. 04 SERVICE MANUAL Service Electronics Gen. 3
64-xx Gen. 3 – DPM Gen. 3 – PEM – ALX 92x Gen. 3 – ALX 73x (PMA)
11
Lithium Battery
The CPU board is equipped with a realtime clock, which keeps its setting, if
the printer is switched off. This is done by a lithium battery on the board.

The battery is not rechargeable !

The battery must be UL-listed!
Battery type Panasonic CR2032 or an equivalent battery type.
Specifications
Battery
replacement
1. Switch off the printer. Disconnect the power cord.
2. Take off the rear hood.

Prior to installation of the new battery: wipe the battery
and the equipement terminal clean using a dry cloth.

Ensure, that dust and other foreign substances will not
cause shorting between the poles.

When handling batteries, wear finger covers or gloves
made of rubber, cotton, etc. to protect the battery from dirt.
3. Take used battery out of the socket; insert the new
battery.

Take care of the correct polarity (see fig. right)!
4. Reassemble the rear hood.
5. Reconnect the printer to the mains and switch it on.
6. Set time and date (
SYSTEM PARAMETER > Realtime clock
).
WARNING!
Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the man-
ufacturer.

Take care of the correct polarity when replacing the battery.

Discard used batteries according to the manufacturer´s instructions.
AVERTISSEMENT!
Il y a danger d´explosion s´il y a remplacement incorrect de la batterie.

Remplacer uniquement avec une batterie du même type ou d´un type
recommendé par le constructeur.

Mettre au rébut les batteries conformément aux instructions du fabricant.
Nominal voltage 3 V
Nominal capacity 220 mAh
Continous standard load 0.2 A
Operating temperature -30 to +60 °C
Max. abnormal charging current 5.0 mA
[Tab. 2] Battery type CR2032 - specifications and dimensions.