Novexx Solutions ALX 92x, Service Manual

Page: 336 / 824

12/14 Rev. 05 SERVICE MANUAL Service Electronics
64-xx Gen. 2 – DPM Gen. 2 – ALX 92x Gen. 2
23
Firmware update
The firmware of the USI can be updated in the following ways:
•
Exchanging the appropriate controller on the USI board (see Fig. 11 ).
•
Loading a firmware file (same procedure as for updating the printer firmware).
This procedure requires the following:
– Controller version: V6-T36 or higher
– Printer firmware: version 4.30 or higher
Article number of the controller with the most recent firmware: A3379.
Version check Displaying the installed controller version:
•
Parameter menu:
SERVICE DATA > MODULE FW VERS. > USI interface
•
Status printout
PRINT INFO > Service status
, entry „Peripheral driver/USI interface“
Displaying the installed printer firmware:
•
Parameter menu: SERVICE DATA > MODULE FW VERS. > System version
•
Status printout
PRINT INFO > Printer status
[11] The controller (1) contains the USI firmware.
Exchanging the
controller 1. Switch the printer off, pull out the mains connector.
2. Open the rear hood.

For details, refer to topic section „General Service“, section „Housing“, chap-
ter „Rear hood“.
3. Take the controller (1) out of the socket.
4. Insert the new controller into the socket.

The dent in the controller housing must show in the pictured direction
(see
Fig. 11 )!
Z
01
51.
cd
r
