Novexx Solutions ALX 92x, Service Manual

Page: 432 / 824

06/16 Rev. 04 SERVICE MANUAL Service Electronics Gen. 3
64-xx Gen. 3 – DPM Gen. 3 – PEM – ALX 92x Gen. 3 – ALX 73x (PMA)
63
Preparing the light barrier sensor cable

Steps 4, 5 and 6: The contact springs
[50A][51A] must engage in the bushing
housing cutouts [50B][51B]!
4. Insert the brown lead of the light barrier
sensor cable into the 4-pin bushing
housing as shown [50].
5. Insert the blue lead of the light barrier
sensor cable into one of the 1-pin bushing
housings as shown [51].
6. Insert the black lead of the light barrier
sensor cable into the other 1-pin bushing
socket in the same way.
7. Thread the light barrier sensor cable leads
[52A] through the opening in the housing.
8. Lead the board plate mounted on the light
barrier sensor cable [52B] through the
opening in the housing, rotating it slightly.
9. Screw the plate board [53A] onto the
housing (2 screws).

The photo [53] shows assembly on a RH
machine. On LH machines, the plate board
is mounted rotated through 180×!
Continued overleaf.
[50] Insert the spring contact into the 4-pin bushing housing.
[51] Insert the spring contact into the 1-pin bushing housing.
[52] Insert the board plate into the side panel through the open-
ing.
[53] Screw on the board plate (ALX/RH).
A
B
A B
A
B
A