Novexx Solutions ALX 92x, Service Manual

Page: 742 / 824

04/16 Rev. 11 USER + SERVICE MANUAL /Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
53
5145 Rewinder full
(ALX 92x with M5A motor output stages only)
Status The maximum permitted diameter (205mm) for the rewinder roll has been
reached.
This error can only occur if the end of a new label roll was glued on to
backing paper that had already been wound onto the rewinder.
Measure  Remove the rewound backing paper.
 Press the Enter-key to confirm the error message.
5150 No USI interface
Status (DPM / PEM / ALX 92x only)
This error appears, if no USI is detected while the printer is powering up.
Measure  Check, if the USI is defective or not built in.
5151 Applic. interf.
Applicator interface
Status (DPM / PEM / ALX 92x only)
Neither Applicator Interface (AI), nor USI are connected to the device.
Measure  Connect a USI or AI to the device.
5152 Winding direct.
(ALX 92x with M5A motor output stages only)
Status The backing paper end is not correctly attached to the rewinder mandrel.
Wrong machine type selected ( SPECIAL FUNCTION > Printer type ).
 Attach the backing paper web to the rewinding mandrel as described in the
user manual.
 Setting „RH“ at a LH machine or vice versa.
5200 Home position
Status The applicator did not reach its home position within the given time frame.
Possible causes:
•
The applicator is jammed
•
Applicators driven by compressed air: The air supply may be interrupted or
switched off
•
Cable not connected properly
Measure

Check cable and compressed air connections; reconnect them properly, if
necessary.
 May the applicator move unhindered? – remove any obstacles.