Novexx Solutions ALX 92x, Service Manual

Page: 669 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
147
Sensor adjust
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6

Parameter only appears in production mode.

For detailed instructions sensor adjustment, please refer to the service
manual, topic section "Service Electronics", paragraph "Settings".
Sensor test
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6

The description of the sensor test can be found in the printer service manual,
topic section „Service Electronics“,
chapter Sensor test  chapter Sensor test
 .
The values displayed are for checking the sensors (sensor check) and can
by adjusted by service personnel.
Cutter test
64-xx AP 4.4 AP 5.4 AP 5.6
Makes it possible to test the cutter function without having to set the para-
meter
SYSTEM PARAMETER > Periph. device
to „cutter“.
Press Cut Key Triggers a cut, if a cutter is installed. Without a cutter nothing will happen.
Matend adjust
AP 4.4 AP 5.4
These printer types are equipped with a single light sensor which is designed
to detect both, punches and material end. The sensor must be able to detect
three different states:
•
No material
•
Only backing paper
•
Backing paper + label face
The parameter
SERVICE FUNCTION > Matend adjust
can set the limit between being
recognized as „only backing paper“ or as „material end“.

For further information read the Service Manual, topic section
Service Electronics /, „Setting the material end sensor“.
yy Level : xx Setting range: 0 to 255; Step width: 1; Default setting: 20
Matend tolerance
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6
Material end tolerance