Novexx Solutions ALX 92x, Service Manual, Page: 214 / 824

06/16 Rev. 09 SERVICE MANUAL Service Mechanics
DPM – PEM – ALX 92x
16
Material dancer lever (ALX)
Tools
•
Screwdriver, medium
•
2.5 mm hexagon spanner
Dismantling
1. Dismantle material unwinder (see above).
2. Remove locking ring [25B].
3. Unhook the spring [25A].
4. Pull the damcer lever off the axle.
To replace the brake lining [25C]:

Unscrew the brake lining fastening screw.
Take out the brake lining.
Adjusting the dancer lever spring
At the dancer lever are two holes [26A,B],
into which the spring can be hooked. The
recommended position depends on the la-
bel length and on the print speed.

Choose the hook-in position in a way that
the dancer lever never crushes against the
outer limit bloc [26C] - neither with a new la-
bel roll, nor with a nearly empty roll.
B
A
C
[25] Upper dancer lever (ALX/RH)
[26] Hook-in position of the retaining spring at the dancer lever:
A Position for use with short labels and low print speed.
B Position for use with long labels and high print speed.
A
B
C