Novexx Solutions ALX 92x, Service Manual

Page: 751 / 824

04/16 Rev. 11 USER + SERVICE MANUAL /Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
62
6009 MLI Speedo data
Status Defective speedo fonts.
Measure  Load the firmware new.

Refer to the service manual, topic section "Firmware".
6010 Printengine soft
Status General software error.
Measure

Switch printer off and then back on again after thirty seconds.

Please read the notes in section General software errors  .
6012 Start next job
Status The message appears at the end of a printjob, if the single job mode
(
SYSTEM PARAMETERS > Single job mode
) is activated. It indicates, that the next
printjob should be started.
Measure

Acknowledge by pressing the online button. Start next printjob.
6030 Param. checksum
Status Wrong parameter checksum.
Measure  None. The message is merely informativ.
6031 New Parameters
Status By loading a new firmware version, some new parameters have been
added to the parameter menu.
Measure  None. The message is merely informativ.
6101 No sensor found
Status Error during the running of the "Sensor Test" service function.
Measure  Acknowledge by pressing the online button.

Contact service technician.
6200 Filesystem regis
Status General software error.
Measure  Switch printer off and then back on again after thirty seconds.

Please read the notes in section General software errors

.
6201 File sys. format
Status Error during formatting of the RAM disk or the memory card.
Measure  Switch printer off and then back on again after thirty seconds. If the error
message continues to appear, please contact the manufacturer.
6202 Drive open
Status Accessing the memory card failed.