Novexx Solutions ALX 92x, Service Manual

Page: 676 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
154

A setting description for the dancer arm of the ALX 92x backing paper rewin-
der can be found in the Service Manual, topic section „Service Electronics“,
chapter „Settings“ > Light sensor at the rewinder dancer lever (ALX 92x)  .
loose xxx Setup of the loose dancer arm (xxx = actual sensor value).
tightened xxx
Setup of the tightened dancer arm (xxx = actual sensor value).
The setting follows in both cases this scheme:
1. Bring the dancer arm to its loose position.
2. Press the cut button (ALX 92x: Apply button)
3. Pull the dancer arm tight.
4. Press the Online button.
Rewinder values
64-xx ALX 92x AP 5.4 AP 5.6

64-xx AP 5.4 /AP 7.t : Only with „Rewinder 2000“ installed.

ALX 92x: Only valid for backing paper rewinder.
Shows the values of the position sensor at the rewinder dancer arm in middle/
tightened and in loose position.
•
xxx = Sensor value in loose position
•
text = Sensor type (Opto = light barrier; Hall = hall sensor; ???? = no explicit
sensor type)
•
yyy = Sensor value in one of the following positions:
–
Middle for 64-xx with „Rewinder 2000“ and for ALX 92x with R04A rewinder
motor output stage (--> 01/2012, recognizable with SYSTEM PARAMETER
>MODULE FW VERS. > Rewinder driver
= „V2-T36“)
– Tightened for ALX 92x with M5A rewinder motor output stage (01/2012-->,
recognizable with
SYSTEM PARAMETER
>MODULE FW VERS. > Rewinder driver =
„V4-T5“)

For detailed information about setting the rewinder dancer arm refer to:
–
ALX 92x: Service manual, topic section „Electronics Gen. 3“, „Settings“ >
Light sensor at the rewinder dancer lever (ALX 92x)

– Rewinder 2000: Technical Manual Rewinder 2000, topic section
„Attachment, Setup“, chapter „Settings“ > „Setting up 64-xx“ > Adjusting
the sensor 
Rewinder values
xxx <------ text -------> yyy