Novexx Solutions ALX 92x, Service Manual

Page: 212 / 824

06/16 Rev. 09 SERVICE MANUAL Service Mechanics
DPM – PEM – ALX 92x
14
Hood switch

Checking the switch: see topic section
Electronics Gen. 2 , or
Electronics Gen. 3 ,
chapter „Settings“, „Sensor test“.
Tools
Small screwdriver
Dismantling
1. Open the front cover.
2. Remove the hood switch fastening screws
(2 screws).
3. Open the rear hood.

See chapter Housing on page 8.
4. Undo the cable fastenings.
5. Thread the cable end through the opening
in the base plate and disconnect from the
CPU board (marked "COS").
Assembly
To assemble the device, follow the steps in
the reverse order. Make sure to

When reattaching the cable, make sure
it does not touch any moving parts.
WARNING!
The hood switch is there for your
safety! Putting it out of operation in-
creases the risk of hair, jewellery
etc. being caught.

Do not disable the hood switch!

Regularly check that the hood
switch is working!
[19] Hood switch dismantled.
[20] Hood switch (A) assembled.
[21] Slot (A) of the hood switch on the CPU boards A2292 and
A2293 (Electronics Gen. 2) (CN1109).
[22] Slot (A) of the hood switch on the CPU boards A6621 (Elec-
tronics Gen. 3) (CN1109).
A
A
A