Novexx Solutions ALX 92x, Service Manual

Page: 667 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
145
yes
Increases the counter "Cutter number" by one
no
Doesn´t increase the counter
Serv. data reset
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6

Parameter only appears in production mode.
Sets all counters on the info printout „Service Status“ to zero.

See parameter Service Status  on page 36.
Head dot test
64-xx ALX 92x DPM PEM ALX 73x (PMA)
Checks the print head for defective dots. The test ends with a status
printout [20], listing the defective dots. The printout is also made without hav-
ing found any defective dots.
During the test appears the display:

The printout requires 100 mm wide and 200 mm long label material.
[20] Status printout after successfully proceeded dot check. Upper section: technical data of
the print head; Lower section: list of defective dots.
CAUTION!
Risk of printhead damage.

Never switch off the printer while the dot check is running. If not observed,
dots of the print head can be damaged.
Head dot test
running ...