Novexx Solutions ALX 92x, Service Manual, Page: 437 / 824

06/16 Rev. 04 SERVICE MANUAL Service Electronics Gen. 3
64-xx Gen. 3 – DPM Gen. 3 – PEM – ALX 92x Gen. 3 – ALX 73x (PMA)
68
– 110 with DPM / PEM / ALX 92x / ALX 73x (PMA)
3. Insert standard self-adhesive material (paper label on backing paper) into
the printer.

y should now count at least 100 digits higher than the value measured with
bare backing paper.
4. If y doesn´t match this range: modify the x value by pressing the Apply or
Feed button.
5. Press the online button to save the setting.
By doing so, the punch sensor is ready set.
Reflex LS
Now, the settings of the reflex sensor are displayed:
x: setting value of the LED current.
y: value measured by the sensor.

The reflex LS is an option . If the printer is not equipped with a reflex LS, skip
this section by pressing the online button!
1. Push the reflex mark on the label material over the reflex LS.
2. Set x so that y matches the range of 230..255.
Typical x values with this setting are:
– 200 with 64-xx
– 155 with DPM / PEM / ALX 92x / ALX 73x (PMA)
3. Position the label material with an area without reflex mark over the
reflex LS. The measured value should now...
– match the range of 25..100 and
– lie at least 100 digits below the value measured with reflex mark.
4. If y doesn´t match this range: modify the x value by pressing the Apply or
Feed button.
5. Press the online button to save the setting.
Fullsize LS
Now, the settings of the Fullsize sensor are displayed:
x: setting value of the LED current.
y: value measured by the sensor.

The Fullsize LS is an option . If the printer is not equipped with a Fullsize LS,
skip this section by pressing the online button!
1. Insert some backing paper of standard label material (with the labels peeled
off), to check the sensor measurement.

The material sample must be big enough to cover the LS!
2. Set x so that y matches the range of 25..70.
Sensor adjust
x Reflex y
Sensor adjust
x Fullsz y