Novexx Solutions ALX 92x, Service Manual, Page: 441 / 824

06/16 Rev. 04 SERVICE MANUAL Service Electronics Gen. 3
64-xx Gen. 3 – DPM Gen. 3 – PEM – ALX 92x Gen. 3 – ALX 73x (PMA)
72
[2] Setting positions of the rewinder dancer lever
(schematic; ALX 92x LH; for rewinders driven by a R04A output stage)
3. If the values don´t match the scheme: Set the potentiometer [3A] so that xxx
in the middle is at least 90 increments higher than the value with the dancer
arm at the loose end.
[3] Setting potentiometer (A) of the dancer lever sensor (B).

If the required values are not successfully setable, the sensor board must be
replaced.
See topic section Mechanics

, section „Material transport“, „Dancer lever
sensor“.
If the showed values are correct:
4. Move the dancer lever to the loose end [2]. Press the Apply button .
Display:
5. Move the dancer lever to the middle [2] and hold it there. Press the Online
button .
6. Restart the device.
The sensor is ready set.
Rewinder adjust
middle
xxx
xxx + min. 90
xxx
Stopper Stopper
middle
loose
A
B