Novexx Solutions ALX 92x, Service Manual

Page: 357 / 824

12/14 Rev. 05 SERVICE MANUAL Service Electronics
64-xx Gen. 2 – DPM Gen. 2 – ALX 92x Gen. 2
44
Settings
Sensor setting

The button designations mentioned in this description count only for 64-xx
printers. With DPM, PEM or ALX 92x, please press the
Apply button instead
of the Cut button!
LS LS means light sensor.
Proceed as follows to set the sensors:
1. Switch on the printer while you keep the Feed and Prog buttons pressed for
approx. 5s. After the printer has started, „Enter code“ is displayed.
2. Press the following buttons one after the other:
Cut, Online, Feed, Cut, Online, Online, Online .
3. Call the parameter
SERVICE FUNCTION > Sesor adjust
.
Material-end-LS This text is displayed:
The number on the left side is the setting value of the LED current
(standard: 220).
The number on the
right side is the value measured by the sensor
(here: 255).
The higher the setting value, the lower is the measured value.
4. Remove the label material from the material-end-LS. The measured value
should now change to 0. If not, increase the setting value to 220.
5. Decrease the setting value by pressing the Cut button, until the measured
value changes to 255.
6. 64-xx : Increase the setting value by 30.
DPM/PEM/ALX 92x : Increase the setting value by 5.
The measured value changes to 0.
7. Insert some label material. The measured value should now be 255.

The punch may not be recognized as material end! If this is the case, adjust
the setting once more!
8. Press the online button to save the setting value.
Punch LS Now, the settings of the punch sensor are displayed:
The number on the left side is the setting value of the LED current
(default: 70).
The number on the
right side is the value measured by the sensor (here: 12).
9. Insert some backing paper of standard label material (with the labels peeled
off), to check the sensor measurement.
Inserting material means here inserting a material sample into the LS fork.

The material sample must be big enough to cover the LS!
10. Set the setting value to 75 ±5 by pressing the Cut or Feed button
respectively. The measured value should match the range of 11..25.
Sensor adjust
220 Matend 255
Sensor adjust
70 Punch 12