Novexx Solutions ALX 92x, Service Manual, Page: 570 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
48
Batch Mode
•
The printer can print the whole label surface.
•
Dispensing of the label takes place during printing. Printing of the next label
is interrupted until the label is completely dispensed.
•
The output volume is at its maximum level.

The Batch mode is optimised for printing and dispensing at high speeds.
Due to this, it is not possible to use all features awaliable in modes
Normal 1:1 or Real 1:1 . Also consider, that printing data must be available on
time and in sufficient quantity.

The following Job/Parameter-combinations must not be used:
•
Jobs with counter fields
•
Jobs with variable fields
•
SYSTEM PARAMETER > Dispensing mode must be set to "fast".
•
The USI reprint function is not supported.
DP INTERFACE > Reprint signal
must be
set to "deactivated".
•
Foil save

A graphic can be found under
PRINT PARAMETERS > Cut mode > Batch mode
.
Real 1:1 Mode
(Default setting)
•
The printer can print the whole label surface.
•
After dispensing a label, the beginning of the next label is drawn back under
the print head.
•
The output volume is lower than in Batch Mode or Normal 1:1 Mode .

A graphic can be found under PRINT PARAMETERS > Cut mode > Real 1:1 mode .
Dispenseposition
64-xx ALX 92x DPM AP 5.4 AP 5.6

Only with
SYSTEM PARAMETER
> Periph. device = „Tear-off edge“.
Dispense position
Adjusts the dispense position in or against the feed direction. Depending on
the set dispense position, the dispensed label sticks to the backing paper with
a more or less wide strip [12]. The required width of this strip depends on the
further processing.
[12] Dispense position (= stopp position) of the dispensed label.
x.x mm Setting range: -30.0 to +20.0 mm; Unit interval: 0.1 mm; Default
setting: -6.0 mm
Dispensed label
Dispense position
Dispensing edge
Backing paper
Z0040E
.cdr