Novexx Solutions ALX 92x, Service Manual

Page: 547 / 824

1. Only 64-xx dispenser with 4“ printhead 2. Only if SYSTEM PARAMETER > Ribbon autoecon. = „On“, „On Turbo“ or „Thermal/headlift“ 3. Only with 8-Dot-Emulation 4. Only with 64-08 5. Only with rewinder option 6. Only with cutter 7. Only
with USI interface 8. Only if SYSTEM PARAMETER > Gap detect. mode = Autom. feed back 9. Only with at least one data block stored in the flash memory 10. Only if SYSTEM PARAMETER > Print Interpret. = „ZPL Emulation“ 11. Only with I/
O board 12. Only if PRINT PARAMETERS > Punch mode = Manual 13. Only in production mode 14. Only with 64-xx dispenser 15. Only if SYSTEM PARAMETER > Autom. dot check = Continuous 16. For details read parameter description 17.
Only with 64-04/05/06 18. Only with installed RFID option 19. Only if DP INTERFACE > Interface type = USI Applicator 20. Only with SYSTEM PARAMETER > Dispensing edge = „User defined“ 21. Not with 64-xx dispenser 22. Only with an
activated RFID option 24. With connected remote display only 25. With Applicator Interface only 26. Only OLV option activated 27. Depends on the applicator type 28. Only if INTERFACE PARA > NETWORK PARAM. > WEB server = „On“ 29.
Availability depends on device conf. 30. Only with a CF card inserted 31. Only with a WLAN CF card inserted 32. Only if INTERFACE PARA > NETWORK PARAM. > Time client = „On“ 33. Only if SYSTEM PARAMETER > Periph. device = „Tear-
off edge“ 34. Only if SYSTEM PARAMETER > Periph. device = „Dispenser“ 35. Only if DISPENSER PARA > Transport mode = „Dual motors“ 36. Only if DISPENSER PARA > Speed Adaption = „On“ 37. Only if DISPENSER PARA > Multi label
mode = „x labels/start“ 38. Only if DISPENSER PARA > Multi label mode = „3 labels/start“ 39. Only PEM 39. Only if CPU board index is -06 or lower
05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
25
A
LX
73x (
P
M
A
) op
.
Pa
ra
m
et
er
s
ALX 73x (PMA) operator parameters
PRINT INFO PRINT PARAMETERS SYSTEM PARAMETER APPLICATOR PARA 25 SPECIAL FUNCTION SERVICE FUNCTION
Printer status Print speed Light sens. type Dwell time 25/27 Delete job Head dot test
Memory status Feed speed Ribbon autoecon. Blow on time 25/27 Delete spooler Print test
Font status Material type Ribbon eco. limit Restart delay 25 Store Parameters
Flashdata status 9 Material length Print contrast Position timeout 25/27 Store Diagnosis
Service status Material width
Dottest endless Print direction
Dottest punched X – print offset
Reference label Y – print offset
F
W
6.60