Novexx Solutions ALX 92x, Service Manual

Page: 565 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
43
Print direction
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6
[9] Orientation of the printout „Foot first“ (A) or „Head first“ (B).
Foot first (Default) Orientation of the printout according to [9A].
Head first Orientation of the printout according to [9B]. Mind the following:

Define the „true“ label length (without gap length) in parameter
PRINT
PARAMETERS > Material length
. If the label gap is wider than 5 mm, the parameter
SYSTEM PARAMETER > Miss. label tol.
must be set to a value more than zero.

The distance between material base line and the first printable dot is
1 mm. To keep this distance while printing „head first“, the material width
must be calculated as follows::
, with
b
Mat
: Material width
b
Bp
: Backing paper width
Punch offset
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6
The zero position can be determined offset in millimetre units from the detect-
ed gap position.

The value is overwritten by the appropriate Easy Plug command when
sending label formats.
xxx mm Setting range: -8 to +max. label length; Unit interval: 0,1mm
Default setting: 0 mm
Maximum offset in feed direction: -8 mm
Minimum offset against feed direction: +max. label length
A B
Printer
Printout
b
Mat
b
Bp
2 mm – =