Installation Manual
AI retrofitting kit for ALX 92x
03/2016 | 00
11
Installation
INSTALLING THE
EXTERNAL POWER
SUPPLY KIT
Exterior connector
1. Switch off the ALX 92x and disconnect the power
plug.
2. Remove the rear cover on the connector side.
How? - See service manual ALX 92x.
3. Remove the dummy plug from the side plate [12A].
Machines, which were built before 7/2006 are
missing that hole in the side plate. In those
cases, there are two possibilities to proceed:
– Drilling the hole: see fig. [13]
– Replacing the side plate by a side plate with
hole (article numbers: LH: A2819, RH: A2692)
When drilling the hole, pay attention that no
swarf can fall on the power supply: Remove the
power supply or cover it completely. No swarf may
rest inside the machine!
4. Insert the M12 connector into the hole and fasten it
with the hex nut.
5. Unplug the white connector [14A] on the AI board,
which belongs to the voltage supply cable (A4999).
6. Instead, connect the white connector belonging to
the cable leading to the M12 connector.
Continued overleaf.
[12] Remove the dummy plug at pos. A (LH machine).
[13] Position of the hole in the side plate (LH machine).
[14] Cable A4999 on the AI board (RH machine).
A
33 mm
130 mm
16 mm
A
Summary of Contents for ALX 92x
