Novexx Solutions ALX 92x, Service Manual, Page: 613 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
91
Tear-off edge
Sets the printer firmware to the tear-off edge option. The punch is fed forward
to the tear-off edge.
Dispenser Setting for 64-xx AP 5.4 /5.6 dispenser version.

64-04/05 only: After selecting this value, the parameter
SPECIAL FUNCTION >
Disp. Head Offs.
appears automatically, if the parameter
SPECIAL FUNCTION >
Printhead type
is set to „KCE 4 Inch“.

See parameter Disp. Head Offs.

on page 123.

See parameter Printhead type  on page 122.
Intern Rewinder AP 5.4/5.6 dispenser only: Setting for printer operation in „internal rewinder“
mode, that is operation with a deflector and without dispensing edge.
Tear-off + sensor
AP 5.4 only: Setting for using the dispensing edge as tear-off edge. The
punch is fed forward to the dispensing edge.
TCS AP 7.t only: Textile Cutter-Stacker
Disp. with LTSI Setting for operation of a LTSI applicator, see Technical Manual LTSI 
Singlestartquant
64-xx ALX 92x DPM PEM AP 4.4 AP 5.4 AP 5.6
Determines the label quantity, which will be printed after a start signal.
xx
Setting range: 1 to 10; Unit interval: 1; Default setting: 1
Head disp dist
(Distance printhead - dispensing edge)
64-xx ALX 92x DPM

64-xx: 64-xx dispenser only and only with
SYSTEM PARAMETER >
Dispensing edge = „User defined“
For setting the distance between printhead and dispensing edge.
xxx.x mm Setting range: 10.0 to 100.0 mm; Unit interval: 0.1 mm; Default setting: 20
mm
External signal
64-xx ALX 92x DPM PEM AP 4.4 AP 5.4 AP 5.6
The parameter determines, if and how an incoming signal at the - optional -
single start connector will be interpreted.
Off Signal interpretation disabled.
Singlestart The signal triggers the printing of a single label. This setting may be used e.g.
for printing single labels by means of a foot switch.
Stacker full
The signal triggers the display of a status report and stops the printer. This
setting may be used when using a stacker (= stacker full signal).