READ ALL DIRECTIONS
BEFORE PLUGGING
IN DISPENSER.
Important: Do not plug in
dispenser until step 4.
This guide is a general
reference to help you quickly
and easily set up your
AquaCafé.
®
SET COOLER IN
DESIRED LOCATION.
Ensure cooler is located on
a level floor, out of direct
sunlight and at least 4 inches
from a wall.
TURN ON HOT
TANK SWITCH.
Once the hot tank has been
primed, turn on the hot tank
switch that is located on
back of the cooler. Water
temperature will reach as high
as 198º F within 5 minutes.
INSERT DRIP TRAY.
Push the drip tray into the
pocket above the metal
clip on the machine to
snap it together.
WARNING TO
USERS AND PARENTS:
Adult supervision
required. Equipment
dispenses very
hot water.
INSERT WATER BOTTLE.
Use the slot on the right-hand
side of the cooler to pull the
door open. Wipe bottle cap with
paper towel. Peel the label off
the 5-gallon bottle. Remove
the bottle probe from inside the
cooler. Insert probe into bottle,
slide the bottle into cooler and
close the door. (Please wear
gloves when setting up or
replacing water bottles.)
1
PLUG IN DISPENSER.
Dispenser should always be
installed within 6 feet of a power
source. Dispenser should be
plugged into a GFCI electrical
outlet. Do not use extension cords.
Ensure hot tank switch on back of
unit is in the Off “O” position prior
to plugging in.
4
2
5
6
7
3
PURGE WATER TANKS.
The AquaCafé
®
has a self-priming
feature that takes approximately
5 minutes to fill both the hot
and cold tanks. After that time,
dispense water from both the hot
and cold tanks to confirm that
they have filled.
AquaCaf
é
®
is a registered trademark of MTN Products.
©2021 DS Services of America, Inc., dba Primo Water North America.
QUICK START GUIDE
