Novexx Solutions ALX 92x, Service Manual, Page: 210 / 824

06/16 Rev. 09 SERVICE MANUAL Service Mechanics
DPM – PEM – ALX 92x
12
Rear hood (ALX)
The rear hood of the ALX 92x consists of
two identical plastic parts.
Tools
Allen key 3 mm.
Dismantling
1. Remove four screws on each half of the
housing [12A], [13A].
2. Pull the housing parts straight off towards
the back.

The side panel with the electrical
connections is not connected with the pla-
stic part.

Remove the lateral part with the blower
[12B] carefully! The side panel remains on
the plastic part. Disconnect the blower ca-
ble!
Blower (ALX)
The blower is attached to the side panel
[12B] and is removed along with this half of
the housing.
Tools
•
Medium-size cross-head screwdriver
•
Size 7 socket wrench
Dismantling
1. Remove rear hood. To do this disconnect
the blower cable.

You only need to dismantle the half of
the housing that contains the blower.
2. Unscrew the blower from the side panel (2
screws).
Assembly
To assemble the device, follow the steps in
the reverse order. Make sure to

connect the blower in accordance with
the illustration [14].
A A
[12] Top fastening screws.
A A
A
B
[13] Bottom fastening screws.
[14] Connect the blower to the power supply.
A