Dell Networking S4810, Reference Manual

Page: 880 / 1761

managementet
hernet Enter the keyword
managementethernet
for the
Management interface on the Primary RPM.
Defaults Not configured.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000 and added support for IPv6.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Usage
Information When a static route (or a protocol route) overlaps with Management static route,
the static route (or a protocol route) is preferred over the Management Static route.
Also, Management static routes and the Management Connected prefix are not
reflected in the hardware routing tables. Separate routing tables are maintained for
IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
interface ManagementEthernet — configures the Management port on the system
(either the Primary or Standby RPM).
speed (Management interface) — sets the speed for the Management interface.
show arp
Display the ARP table.
S4810
Syntax
show arp [vrf vrf-name ] [interface interface | ip ip-address
[ mask ] | macaddress mac-address [ mac-address mask ]] [retries]
[static | dynamic] [inspection {database | statistics][summary]
880
IPv4 Routing