Dell Networking S4810, Reference Manual

Page: 1191 / 1761

• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
then the slot/port information.
• For Port Channel groups, enter the keywords
port-
channel
then a number. For the C-Series and S-Series,
the range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a VLAN, enter the keyword
vlan
then a number from
1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
Command
Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Modified to include the keyword
default
.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information
Although the passive interface does not send or receive routing updates, the
network on that interface is still included in OSPF updates sent using other
interfaces.
The
default
keyword sets all interfaces as passive. You can then configure
individual interfaces, where adjacencies are desired, using the
no passive-
interface interface
command. The
no
form of this command is inserted into
the configuration for individual interfaces when the
no passive-interface
interface
command is issued while
passive-interface default
is
configured.
This command behavior has changed as follows:
passive-interface interface
Open Shortest Path First (OSPFv2 and OSPFv3)
1191