Dell Networking S4810, Reference Manual

Page: 749 / 1761

Version 9.4(0.0) Added the support for interfaces.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.4.1.0 Introduced
Usage
Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (
shutdown
) and are not assigned to an
IP address or switchport. To place an interface in Layer 2 mode, ensure that the
interface’s configuration does not contain an IP address and enter the
switchport
command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface
with no default configuration. To delete a tunnel interface, use the
no interface
tunnel tunnel-id
command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the
next hop to the tunnel destination is over a physical interface. If you select any
other interface as the next hop to the tunnel destination, the tunnel interface does
not operate as an ECMP.
Example
Dell(conf)#int tengigabitethernet 0/0
Dell(conf-if-te-0/0)#exit
Dell(conf)#
Related
Commands
interface loopback — configures a Loopback interface.
interface null — configures a Null interface.
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
show interfaces — displays the interface configuration.
Interfaces
749