Dell Networking S4810, Reference Manual

Page: 1640 / 1761

loopguard Enter the keyword
loopguard
to enable STP loop guard on
a port or port-channel interface.
rootguard Enter the keyword
rootguard
to enable STP root guard on
a port or port-channel interface.
portfast
[bpduguard
[shutdown-on-
viol ation]]
Enter the keyword
portfast
to enable Portfast to move the
interface into Forwarding mode immediately after the root
fails.
Enter the optional keyword
bpduguard
to disable the port
when it receives a BPDU.
Enter the optional keyword
shutdown-on-violation
to
hardware disable an interface when a BPDU is received and
the port is disabled.
priority priority Enter keyword
priority
then a number as the priority. The
range is from zero (0) to 15. The default is 8 .
Defaults cost = depends on the interface type; priority = 8
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.10.1 Introduced the
loopguard
and
rootguard
options on the
S4810.
Version 8.4.2.1 Introduced the
loopguard
and
rootguard
options on the
E-Series TeraScale, C-Series, and S-Series.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced the
shutdown-on-violation
option.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
If you enable
portfast bpduguard
on an interface and the interface receives a
BPDU, the software disables the interface and sends a message stating that fact.
1640
Spanning Tree Protocol (STP)