Dell Networking S4810, Reference Manual

Page: 1401 / 1761

To ensure that only specific interfaces are receiving and sending data, use the
passive-interface
command with the
neighbor
command.
Related
Commands passive-interface — sets the interface to only listen to RIP broadcasts.
network
Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this
command.
S4810
Syntax
network ip-address
To disable RIP for a network, use the
no network ip-address
command.
Parameters
ip-address Specify an IP network address in dotted decimal format. You
cannot specify a subnet.
Defaults No RIP network is configured.
Command
Modes ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
Usage
Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address the
network
command
specifies.
Routing Information Protocol (RIP)
1401