Dell Networking S4810, Reference Manual

Page: 1668 / 1761

Configuration of IPv6 commands over decapsulate-any tunnel causes an error.
tunnel source
Set a source address for the tunnel.
S4810
Syntax
tunnel source { ip-address | ipv6–address | interface-type-
number | anylocal}
To delete the current tunnel source address, use the
no tunnel source
command.
Parameters
ip-address Enter the source IPv4 address in A.B.C.D format.
ipv6–address Enter the source IPv6 address in X:X:X:X::X format.
interface-type-
number
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
then the slot/port information.
• For a 1–Gigabit Ethernet interface, enter the keyword
GigabitEthernet
then the slot/port information.
• For a port channel interface, enter the keywords
port-
channel
then a number from 1 to 128.
• For a 10–Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a VLAN interface, enter the keyword
vlan
then a
number from 1 to 4094.
anylocal
Enter the
anylocal
command to allow the multipoint
receive-only tunnel to decapsulate tunnel packets destined
to any local ip address.
Defaults none
Command
Modes INTERFACE TUNNEL (conf-if-tu)
Command
History
Version 9.4(0.0) Added the tunnel source anylocal command.
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Added an optional keyword “anylocal” to the tunnel source command. The
anylocal argument can be used in place of the ip address or interface, but only with
the multipoint receive-only mode tunnels. The tunnel source
anylocal
command
allows the multipoint receive-only tunnel to decapsulate tunnel packets addressed
1668
Tunneling