Dell Networking S4810, Reference Manual

Page: 986 / 1761

ignore-lsp-errors
Ignore LSPs with bad checksums instead of purging those LSPs.
S4810
Syntax
ignore-lsp-errors
To return to the default values, use the
no ignore-lsp-errors
command.
Defaults In IS-IS, the default deletes LSPs with internal checksum errors (
no ignore-lsp-
errors
).
Command
Modes ROUTER ISIS
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Usage
Information IS-IS normally purges LSPs with an incorrect data link checksum causing the LSP
source to regenerate the message. A cycle of purging and regenerating LSPs can
occur when a network link continues to deliver accurate LSPs even though there is
a link causing data corruption. This process could cause disruption to your system
operation.
ip router isis
Configure IS-IS routing processes on an interface and attach an area tag name to the routing process.
S4810
Syntax
ip router isis [ tag ]
To disable IS-IS on an interface, use the
no ip router isis [ tag ]
command.
Parameters
tag (OPTIONAL) The tag you specify identifies a specific area
routing process. If you do not specify a tag, a null tag is
assigned.
986
Intermediate System to Intermediate System (IS-IS)