Dell Networking S4810, Reference Manual

Page: 751 / 1761

Usage
Information
The
interface group
command will create all the non-existent VLANs specified
in the range. On successful command execution, the CLI switches to the interface
group context.
The configuration commands inside the group context will be the similar to that of
the existing range command.
Note: For release 9.4(0.0), the group command is supported only for VLANs and
physical interfaces.
Example
Dell(conf)#interface group ?
fortyGigE FortyGigabit Ethernet interface
gigabitethernet GigabitEthernet interface IEEE 802.3z
tengigabitethernet TenGigabit Ethernet interface
vlan VLAN keyword
Dell(conf)# interface group vlan 1 - 2 , tengigabitethernet
0/0
Dell(conf-if-group-vl-1-2,te-0/0)# no shutdown
Dell(conf-if-group-vl-1-2,te-0/0)# end
interface loopback
Configure a Loopback interface.
S4810
Syntax
interface loopback number
To remove a loopback interface, use the
no interface loopback number
command.
Parameters
number Enter a number as the interface number. The range is from 0
to 16383.
Defaults Not configured.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Interfaces
751