Dell Networking S4810, Reference Manual

Page: 801 / 1761

Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
Usage
Information Splitting a 40G port into 4x10G port is supported on standalone and stacked units.
Split ports cannot be used as stack-link to stack an S4810 system.
The quad port must be in a default configuration before it can be split into 4x10G
ports. The 40G port is lost in the config when the port is split, so be sure that the
port is also removed from other L2/L3 feature configurations.
The system must be reloaded after issuing the CLI for the change to take effect.
This command cannot be used if LR4 optics are inserted on the 40G interface.
Example (stack
unit – Warning
message when
13 ports are
configured in
any port range)
Dell(conf)#stack-unit 0 po 48 po q
Maximum number of ports that can be made Quad mode in the
range <0-63> is configured. Ports 52,56,60, will be disabled
on reload.
Do you wish to continue? [confirm yes/no]:yes
Please save and reset unit 0 for the changes to take effect.
Dell(conf)#
switchport
Place an interface in Layer 2 mode.
S4810
Syntax switchport [backup interface {gigabit slot/port | tengigabit
slot/port | fortyGigE slot/port | port-channel number }]
To remove an interface from Layer 2 mode and place it in Layer 3 mode, enter the
no switchport
command. If a switchport backup interface is configured, first
remove the backup configuration. To remove a switchport backup interface, enter
the
no switchport backup interface {gigabit slot/port |
tengigabit slot/port | fortyGigE slot/port | port-channel
number}
command.
Interfaces
801