Dell Networking S4810, Reference Manual

Page: 820 / 1761

• A non-IP payload is going out of Layer 2 LAG interface that is a member of
VLAN with an IP address
Example
Dell#show port-channel-flow outgoing-port-channel 1 incoming-
interface gi 3/0
source-mac 00:00:50:00:00:00 destination-mac 00:00:a0:00:00:00
Egress Port for port-channel 1, for the given flow, is Te
13/01
Time Domain Reflectometer (TDR)
TDR is useful for troubleshooting an interface that is not establishing a link; either it is flapping or not
coming up at all. TDR detects open or short conditions of copper cables on 100/1000 Base-T modules.
Important Points to Remember
• The interface and port must be enabled (configured—refer to the
interface
command) before
running TDR. An error message is generated if you have not enabled the interface.
• The interface on the far-end device must be shut down before running TDR.
• Because TDR is an intrusive test on an interface that is not establishing a link, do not run TDR on an
interface that is passing traffic.
• When testing between two devices, do not run the test on both ends of the cable.
tdr-cable-test
Test the condition of copper cables on 100/1000 Base-T modules.
S4810
Syntax
tdr-cable-test interface
Parameters
interface Enter the keyword
GigabitEthernet
then the slot/port
information for the 100/1000 Ethernet interface.
Defaults none
Command
Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
820
Interfaces