Dell Networking S4810, Reference Manual

Page: 1680 / 1761

Related
Commands uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
downstream
Assign a port or port-channel to the uplink-state group as a downstream interface.
S4810
Syntax
downstream interface
To delete an uplink-state group, enter the
no downstream interface
command.
Parameters
interface Enter one of the following interface types:
• Fast Ethernet:
fastethernet { slot/port | slot/
port-range }
• 1 Gigabit Ethernet:
gigabitethernet { slot/port |
slot/port-range }
• 10 Gigabit Ethernet:
tengigabitethernet { slot/
port | slot/port-range }
• Port channel:
port-channel { 1-512 | port-
channel-range }
Where
port-range
and
port-channel-range
specify a
range of ports separated by a dash (-) and/or individual
ports/port channels in any order; for example:
gigabitethernet 1/1-2,5,9,11-12 port-channel
1-3,5
. A comma is required to separate each port and port-
range entry.
Defaults none
Command
Modes UPLINK-STATE-GROUP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0 Introduced on the S4820T.
1680
Uplink Failure Detection (UFD)