Dell Networking S4810, Reference Manual

Page: 1535 / 1761

Parameters
rate-limit rate Enter the keyword
rate-limit
followed by a number for
the rate-limit for tunneled packets on the VMAN. The range
is from 64 to 320.
stp Enter the keyword
stp
to enable protocol tunneling on a
spanning tree, including STP, MSTP, RSTP, and PVST.
Defaults none
Command
Modes CONF-IF-VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guid .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.1 Added support for
802.1X
,
E-LMI
,
GMRP
,
GVRP
,
LLDP
,
LACP
,
MMRP
,
MVRP
, and
OAM 802.3ah
protocol traffic to the E-
Series ExaScale.
Version 8.2.1.0 Introduced on the C-Series, E-Series, and E-Series ExaScale.
Version 7.4.1.0 Introduced
Example
Dell#conf
Dell(conf)#interface vlan 2
Dell(conf-if-vl-2)#vlan-stack compatible
Dell(conf-if-vl-2)#member Gi1/2-3
Dell(conf-if-vl-2)#protocol-tunnel stp
Dell(conf-if-vl-2)#protocol-tunnel enable
Related
Command show protocol-tunnel — displays tunneling information for all VLANs.
protocol-tunnel destination-mac
Overwrite the BPDU destination MAC address with a specific value.
S4810
Syntax
protocol-tunnel destination-mac xstp address
Parameters
stp Change the default destination MAC address used for L2PT
to another value.
Service Provider Bridging
1535