Dell Networking S4810, Reference Manual

Page: 438 / 1761

To disable sender-side loop detection, use the
no neighbor { ip-address |
peer-group-name } sender-side-loopdetect
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name Enter the name of the peer group to enable or disable all
routers with in the peer group.
All routers in the peer group receive routes from a route
reflector.
Defaults Enabled.
Command
Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
This command enables sender-side-loopdetect for a specified BGP neighbor. BGP
does not advertise a route to a peer if the AS-Path of the route already contains the
peer's AS.
NOTE: If you configure a neighbor to accept such routes using the
neighbor
allowas-in
command, you must disable sender-side loop detection for that
neighbor.
Related
Commands bgp client-to-client reflection — enables route reflection between the route
reflector and the clients.
438
Border Gateway Protocol