Dell Networking S4810, Reference Manual

Page: 562 / 1761

Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the
show interface
dcbx detail
command.
debug dcbx
Enable DCBX debugging.
S4810
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail |
mgmt | resource | sem | tlv}
To disable DCBX debugging, use the
no debug dcbx
command.
Parameters
{all | auto-
detect-timer |
config-exchng
| fail | mgmt |
resource | sem
| tlv} Enter the type of debugging, where:
•
all
: enables all DCBX debugging operations.
•
auto-detect-timer
: enables traces for DCBX auto-
detect timers.
•
config-exchng
: enables traces for DCBX configuration
exchanges.
•
fail
: enables traces for DCBX failures.
•
mgmt
: enables traces for DCBX management frames.
•
resource
: enables traces for DCBX system resource
frames.
•
sem
: enables traces for the DCBX state machine.
•
tlv
: enables traces for DCBX TLVs.
Defaults none
Command
Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
562
Data Center Bridging (DCB)