Dell Networking S4810, Reference Manual

Page: 417 / 1761

Defaults Disabled
Command
Modes CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information By default, when you create a neighbor/peer group configuration in the Router
BGP context, this enables IPv4/Unicast AFI/SAFI. When you use
activate
in the
new context, the neighbor/peer group enables for AFI/SAFI.
It is not possible to de-activate a peer from the IPv4 unicast address family.
neighbor add-path
This command allows the specified neighbor/peer group to send/receive multiple path advertisements.
S4810
Syntax
neighbor [ ip-address | peer-group-name ] add-path [send |
receive | both] path-count
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-
name (OPTIONAL) Enter the name of the peer group.
send Enter the keyword
send
to indicate that the system sends
multiple paths to peers.
receive Enter the keyword
receive
to indicate that the system
accepts multiple paths from peers.
both Enter the keyword
both
to indicate that the system sends
and accepts multiple paths from peers.
path-count Enter the number paths supported. The range is from 2 to
64.
Border Gateway Protocol
417