Dell Networking S4810, Reference Manual

Page: 806 / 1761

To disable and remove management egress interface selection (EIS) configurations,
use the
no management egress-interface-selection
command.
Defaults None.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
show ip management-eis-route
Display the management routes used by EIS.
S4810
Syntax
show ip management-eis-route
Defaults None.
Command
Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.2.
(0.0) Introduced on the Z9000, S4810, and S4820T.
Example
Dell#show ip management-eis-route
Destination Gateway State Route Source
----------- ------- ----- ------------
10.11.0.0/16 ManagementEthernet 0/0 Connected Connected
172.16.1.0/24 10.11.192.4 Active Static
show management application pkt-cntr
Display the number of packets for each application type that have taken the management route.
S4810
Syntax
show management application pkt-cntr
Defaults None.
806
Interfaces