Dell Networking S4810, Reference Manual

Page: 442 / 1761

Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
Timer values configured with the
neighbor timers
command override the timer
values configured with any other command.
When two neighbors, configured with different
keepalive
and
holdtime
values,
negotiate for new values, the resulting values are as follows:
• the lower of the
holdtime
value is the new
holdtime
value, and
• whichever is the lower value; one-third of the new
holdtime
value, or the
configured
keepalive
value, is the new keepalive value.
neighbor update-source
Enable the E-Series software to use Loopback interfaces for TCP connections for BGP sessions.
S4810
Syntax
neighbor { ip-address | peer-group-name } update-source interface
To use the closest interface, use the
no neighbor { ip-address | peer-
group-name } update-source interface
command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal
format.
peer-group-
name Enter the name of the peer group to disable all routers within
the peer group.
interface Enter the keyword
loopback
then a number of the
Loopback interface. The range is from 0 to 16383.
Defaults Not configured.
Command
Modes ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
442
Border Gateway Protocol