Dell Networking S4810, Reference Manual

Page: 790 / 1761

show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the
transceiver’s serial number.
Syntax
show interfaces [tengigabitethernet slot/port | fortyGigE slot/
port ] transceiver
Parameters
tengigabitether
net For a 10G interface, enter the keyword
tengigabitethernet
then the slot/port information.
fortyGigE For a 40G interface, enter the keyword
fortyGigE
then the
slot/port information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on theS6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Output augmented with diagnostic data for pluggable media.
Version 7.7.1.0 Removed three fields in the output: Vendor Name, Vendor
OUI, and Vendor PN.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 6.5.4.0 Introduced on the E-Series.
Usage
Information The following describes the
show interfaces transceiver
command shown
in the following example.
Line Description
Rx Power
measurement
type Output depends on the vendor, typically either “Average” or
“OMA” (Receiver optical modulation amplitude).
790
Interfaces