Dell Networking S4810, Reference Manual

Page: 525 / 1761

dcb stack-unit { stack-unit-id | all} {pfc-buffering | unit
stack-unit-id pfc-buffering} pfc-ports { 1-64 } pfc-queues { 1-2 }
To remove the configuration for the PFC buffer on all port pipes in a specified stack
unit, use the
no dcb stack-unit { stack-unit-id | all} {pfc-
buffering | unit stack-unit-id pfc-buffering} pfc-ports { 1-64 }
pfc-queues { 1-2 }
command.
Parameters
stack-unit-id Enter the stack unit identification. The range is from 0 to 5.
pfc-ports
{
1-64 }
Enter the pfc-ports. The range is from 1 to 64.
pfc-queues
{
1-2 }
Enter the pfc-queue number. The range is from 1 to 2.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you configure PFC on a 40GbE port, count the 40GbE port as four PFC-enabled
ports in the pfc-port number you enter in the command syntax.
To achieve lossless PFC operation, the PFC port count and queue number used for
the reserved buffer size that is created must be greater than or equal to the buffer
size required for PFC-enabled ports and lossless queues on the switch.
You must reload the stack or a specified stack unit (use the
reload
command in
EXEC Privilege mode) for the PFC buffer configuration to take effect.
Related
Commands dcb stack-unit pfc-buffering pfc-port pfc-queues — configures the PFC buffer for
all switches in the stack.
Data Center Bridging (DCB)
525