Dell Networking S4810, Reference Manual

Page: 1085 / 1761

show lldp neighbors — displays the LLDP neighbors.
hello
Configure the rate at which the LLDP control packets are sent to its peer.
S4810
Syntax
hello seconds
To revert to the default, use the
no hello seconds
command.
Parameters
seconds Enter the rate, in seconds, at which the control packets are
sent to its peer. The rate is from 5 to 180 seconds. The
default is
30 seconds .
Defaults 30 seconds
Command
Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if- interface -lldp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
management-interface
Enable and configure LLDP protocol parameters on the management interface.
S4810
Syntax
management-interface
To remove LLDP configuration on a management interface, use the
no
management-interface
command.
Link Layer Discovery Protocol (LLDP)
1085