Dell Networking S4810, Reference Manual

Page: 839 / 1761

27
IPv4 Routing
The basic IPv4 commands are supported by Dell Networking operating system on the S4810 platform.
arp
To associate an IP address with a MAC address in the switch, use address resolution protocol (ARP).
S4810
Syntax
arp [vrf vrf-name ] ip-address mac-address interface
To remove an ARP address, use the
no arp ip-address
command.
Parameters
vrf vrf-name Enter a VRF name to configure an ARP entry for that VRF.
Use the VRF option after the keyword
arp
to configure a
static arp on that particular VRF.
ip-address Enter an IP address in dotted decimal format.
mac-address Enter a MAC address in nnnn.nnnn.nnnn format.
interface (OPTIONAL) Enter any of the following keywords and slot/
port or number information:
• For the Management interface, enter the keyword
ManagementEthernet
then the slot/port information.
The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
Defaults Not configured.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
IPv4 Routing
839