Dell Networking S4810, Reference Manual

Page: 274 / 1761

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Related
Commands
ip community-list — configures an Community Access list.
set community — specifies a COMMUNITY attribute.
match interface
To match routes whose next hop is on the interface specified, configure a filter.
S4810
Syntax
match interface interface
To remove a match, use the
no match interface interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• .
• For the loopback interface, enter the keyword
loopback
then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword
port-
channel
then a number. The range is from 1 to 128.
• For a SONET interface, enter the keyword
sonet
then the
slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a VLAN, enter the keyword
vlan
then a number from
1 to 4094 (you can use IDs 1 to 4094).
274
Access Control Lists (ACL)