Dell Networking S4810, Reference Manual

Page: 1066 / 1761

untagged
Add a Layer 2 interface to a VLAN as an untagged interface.
S4810
Syntax
untagged interface
To remove an untagged interface from a VLAN, use the
no untagged interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
Defaults All interfaces in Layer 2 mode are untagged.
Command
Modes INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
Usage
Information
Untagged interfaces can only belong to one VLAN.
In the Default VLAN, you cannot use the
no untagged interface
command. To
remove an untagged interface from all VLANs, including the Default VLAN, enter
INTERFACE mode and use the
no switchport
command.
1066
Layer 2