Dell Networking S4810, Reference Manual

Page: 879 / 1761

Defaults IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-
port).
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Added support for IPv6.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
management route
Configure a static route that points to the Management interface or a forwarding router.
S4810
Syntax
management route {{ ip-address mask | { ipv6-address prefix-
length }} { forwarding-router-address | managementethernet}
To remove a static route, use the
no management route{{ ip-address mask
| { ipv6-address prefix-length }}{ forwarding-router-address |
managementethernet}
command.
Parameters
ip-address
mask Enter an IP address (dotted decimal format) and mask (/prefix
format) of the destination subnet.
ipv6-address
prefix-length Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
format) of the destination subnet. Enter the IPv6 address in
the x:x:x:x::x format followed by the prefix length in the /x
format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
forwarding-
router-address Enter an IP address (dotted decimal format) or an IPv6
address (x:x:x:x::x format) of a forwarding router.
IPv4 Routing
879