Dell Networking S4810, Reference Manual

Page: 252 / 1761

• Use the
no deny {any | mac-source-address mac-source-address-
mask }
command.
Parameters
any Enter the keyword
any
to specify that all routes are subject
to the filter.
mac-source-
address Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask (OPTIONAL) Specify which bits in the MAC address must
match. If no mask is specified, a mask of 00:00:00:00:00:00
is applied (in other words, the filter allows only MAC
addresses that match).
count (OPTIONAL) Enter the keyword
count
to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword
byte
to count bytes
processed by the filter.
log (OPTIONAL, E-Series only) Enter the keyword
log
to log the
packets.
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface. For more information, refer to the “Flow-based
Monitoring” section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide .
Defaults Not enabled.
Command
Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Added the
monitor
option.
252
Access Control Lists (ACL)