Dell Networking S4810, Reference Manual

Page: 1568 / 1761

NOTE: For version 1 and version 2c security models, this
string represents the name of the SNMP community. The
string can be set using this command; however, Dell
Networking OS recommends setting the community
string using the
snmp-server community
command
before executing this command. For version 3 security
model, this string is the USM user security name.
udp-port port-
number
(OPTIONAL) Enter the keywords
udp-port
followed by the
port number of the remote host to use. The range is from 0
to 65535. The default is
162 .
notification-
type (OPTIONAL) Enter one of the following keywords for the
type of trap to be sent to the host:
•
bgp
— Enable BGP state change traps.
•
ecfm
— Enable ECFM state change traps.
•
entity
— Enable entity change traps.
•
envmon
— Enable SNMP environmental monitor traps.
•
eoam
— Enable EOAM state change traps
•
ets
— Enable ets traps
•
fips
— Enable FIP Snooping state change traps
•
lacp
— Enable LACP state change traps.
•
isis
— Enable ISIS adjacency change traps
•
pfc
— Enable pfc traps
•
snmp
— Enable SNMP trap
•
stp
— Enable 802.1d state change traps
•
vlt
— Enable VLT traps
•
vrrp
— Enable VRRP state change traps
•
xstp
— Enable 802.1s, 802.1w, and PVST+ state change
traps
The default is all trap types are sent to host.
Defaults As above.
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0) Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
1568
Simple Network Management Protocol (SNMP) and Syslog