Dell Networking S4810, Reference Manual

Page: 1359 / 1761

service-policy input — applies an input policy map to the selected interface.
policy-map-output
Create an output policy map.
S4810
Syntax
policy-map-output policy-map-name
To remove a policy map, use the
no policy-map-output policy-map-name
command.
Parameters
policy-map-
name Enter the name for the policy map in character format (32
characters maximum).
Defaults none
Command
Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Policy name character limit increased from 16 to 32.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information To assign traffic to different flows using QoS policy, use the Output Policy map.
This command enables Policy-Map-Output Configuration mode (conf-policy-
map-out).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS
using policy maps.
service-policy output — applies an output policy map to the selected interface.
Quality of Service (QoS)
1359