Dell Networking S4810, Reference Manual

Page: 797 / 1761

Defaults The interface is disabled.
Command
Modes INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
The
shutdown
command marks a physical interface as unavailable for traffic. To
discover if an interface is disabled, use the
show ip interface brief
command. Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes different behavior. When a VLAN is
disabled, the Layer 3 functions within that VLAN are disabled. Layer 2 traffic
continues to flow. Entering the
shutdown
command on a port channel disables all
traffic on the port channel and the individual interfaces within the port channel. To
enable a port channel, enter
no shutdown
on the port channel interface and at
least one interface within that port channel.
The
shutdown
and
description
commands are the only commands that you
can configure on an interface that is a member of a port channel.
Related
Commands
interface port-channel — creates a port channel interface.
interface vlan — creates a VLAN.
show ip interface — displays the interface routing status. Add the keyword
brief
to display a table of interfaces and their status.
Interfaces
797