Dell Networking S4810, Reference Manual

Page: 520 / 1761

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0 Introduced on the S4820T.
Version
8.3.12.0 Introduced on the S4810.
Version
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
By default, iSCSI is enabled on the unit and flow control is enabled on all of the
interfaces or if link-level flow control is enabled on one or more interfaces. To
enable DCB, do one of the following:
• Apply the
dcb-input policy
command with the
no pfc-mode
command on
to all the interfaces.
• Disable flow-control on all of the interfaces.
Related
Commands dcb-policy input — applies the input policy with the PFC configuration to an
ingress interface.
PFC Commands
The following PFC commands are supported on the S4810 platform.
clear pfc counters
Clear the PFC TLV counters and PFC statistics on an interface or stack unit.
S4810
Syntax
clear pfc counters [port-type slot/port | stack-unit { unit
number | all } all stack-ports all}]
Parameters
port-type Enter the keywords
port-type
then the slot/port
information.
stack-unit unit
number
Enter the keywords
stack-unit
then the stack-unit number
to be cleared.
all stack-ports
all Enter the keywords
all stack-ports all
to clear the
counters on all interfaces.
Defaults none
Command
Modes EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide .
520
Data Center Bridging (DCB)